Rated by asdf_, July 2, 2008

This works great for my 1/2" loop, especially at the price (even lower with PM). Kinks pretty easy, so don't use it for the bendy parts.      » READ MORE

 Rated by PL_C, June 5, 2008

For a secure, tight fit in 1/2" loops, this tubing is perfect IF you don't need to have tight twists and turns (kinks easily).       » READ MORE

 Rated by Nivek24, May 26, 2008

Works quite well, just get some smart coils for your tighter bends as it does kink quite easily. However, I did my whole loop with it and it works great - no leaks and fits over 1/2" barbs quite nicely.       » READ MORE

 Rated by Moneyless, April 22, 2008

I bought this tubing to use in my loop, (HW Labs BIX240 > D5 Vario > T-Line > Apogee GT > back to BIX240) and it looks and works great. Fits great on 1/2' barbs but it's a squeeze, easy to get on once you've done a few. (Tip: rub a tad of Vaseline on the inside edge of the tube and cut it on a slight angle, slides right on.)      » READ MORE

 Rated by Edward_T, February 27, 2008

I wouldn't recommend this for bend more than 30 degrees. I bought this stuff for the straight tubing in my water cooling system. I used the Tygon 3/8 for connecting to the blocks. This tubing does it's job though and I recommend it.       » READ MORE

 Rated by Brendon_C, February 3, 2008

Decent tubing, kinks pretty easy though. Would buy again if need be due to the higher price of tygon. This is worth the money.       » READ MORE

 Rated by Thomas C, January 14, 2008

Overall a great product for the price, and fits very well on most 1/2" barbs. I would definitely recommend 7/16" tubing when setting up a 1/2" loop as the extra seal provided by that 1/16" difference is nice, and the reduction in flow is negligible. Only thing to note is you may want to pick up some ties or coils if you plan to run tight corners, as the wall on this isn't the thickest out there.      » READ MORE

 Rated by Justin_H, January 10, 2008

This tubing works very well and makes an unbelievably secure fit on 1/2" barbs, I would grab this stuff anytime for my next watercooling setup.      » READ MORE

 Rated by Reap37, January 2, 2008

Bends well with not to much kinks to prevent flow of water. A bit hard to push 7/16" tubing over 1/2" barbs but will fit snugly to enable and prevent leaks from occuring. My recommendation to this product because it has worked well for me.      » READ MORE

 Rated by James_8970, November 27, 2007

I was planning on purchasing some tygon, but thought I'd try this out first. It's a great alternative at a great price, without kinking issues.

This review was modfied by poster @ 11-27-07 05:36 PM      » READ MORE

  Write a Review   |    Read All 13 Member Reviews