Rated by Raffi22, November 14, 2008

These are a harder rubber than the silicone type vibration reducing fan mounts as in Antec cases. They are great if you will be leaving the fan in that one place forever. If you plan on moving your fan, there is a good chance that you will either break them or need a knife.       » READ MORE

 Rated by Georges_A, November 7, 2007

Pretty much basic... I used them to place a fan where screwing was rather impossible in my case. Installing them is simple: either push hard or use tools but it's very basic and you'll be satisfied.      » READ MORE

 Rated by Rod_D, November 5, 2007

Works excellent and fairly easy to install. Needle nose Pliers help if your installing them into an already built case that doesnt have much room for your hands or fingers.      » READ MORE

 Rated by Carlos_T, May 2, 2007

They felt lose at first but the fan puts pressure on them, so the fan dont move around at all like I was scared of at 1st.       » READ MORE

 Rated by Ronaldor9, April 2, 2007

it came with no packagein so that was disapointment but it did reduce vibration on my fan but was difficult to plu g ok product      » READ MORE

 Rated by Sejin, January 19, 2006

I bought two of these 4packs for the front two Nexus 92mm fans in my Antec P150 case, and these are easily the worst rubber fan isolation screws I have ever owned. Two of them broke during installation and the ones that did not break stretched causing the fans to sag from there proper alignment. For nearly a dollar each these are just simply not worth purchasing since the "rubber" used is extremely poor quality and likely provides no vibration dampening.      » READ MORE

 Rated by Sina_R, December 9, 2005

Ok I'm glad NCIX cares enough about us(silent freaks) and carries such a product. You will not hear a big differnce(1 to 2db maybe) depending on the viberation your fan makes.      » READ MORE

 Rated by Jonathan_N, August 20, 2005

This reduce noise, so that means that they do they job. But at the cost of your convenience.       » READ MORE

 Rated by Jordan_19, June 9, 2005

Not much to say really except if you can get them to fit, they will hold your fans in place and reduce noise. The trade off is that they probably can't be re-used. I don't think I'll be able to get them out of my case without cutting them.      » READ MORE

 Rated by Boushard, May 29, 2005

Like write in the review, it's reduce the vibration of fan's but they are difficult to plug on the fan's frame!! :S      » READ MORE

  Write a Review   |    Read All 24 Member Reviews